Projects
Below is a selection of the projects that the mechanic and engineers of Hydrocare have carried out successfully.
Below is a selection of the projects that the mechanic and engineers of Hydrocare have carried out successfully.
Overhaul and modification of a nitrogen cylinder. All cylinders were tested on the specially made test set-up after repair. DNV has ensured that the tests were carried out as prescribed by the customer
For this customer we have overhauled this 14 Ballast valve actuator / powerpack.
For this customer we measured all hoses and installed the new hoses in a very short period of time.
This cylinder was newly made in the workshop. The rod is turned, the eye is welded to the casing, the casing is welded and the eye is welded to the casing. This has been tested and then provided with paint.
In the port of Antwerp, the lifting cylinder was replaced after the star disaster of a motor boat. The eye of the rod had been torn off the old cylinder. The customer provided a new cylinder himself and Hydro Care ensured that it was carefully replaced. The Sternramp was tested after the cylinder was placed and Hydro Care ensured that it functions properly after the new cylinder was placed. The old cylinder was taken to the workshop to overhaul.
the complaint of an anchor winch of a ship was that this oil was leaking from the gearbox to the outside. First, the cause and where the oil came out was searched for. After this a plan was made and we started removing the parts to eventually be able to get to the oil seal to replace it. The link shaft bearings between the drive and the sprocket were also very bad. These were drawn on a drawing and manufactured within 1 day and reassembled with all other parts so that the ship could quickly resume its journey.
